Step-by-Step guide:
You need a master key and a new key
Part 1: Add a G chip key
Connect MS906BT scanner with vehicle via OBD diagnostic socket
Select Hot Function->Immo & Keys
Establishing vehicle communication
Select Key registration
This function registers a new transponder code by inserting a new key.
Step 1:
-Remove the key from key cyliner
-Insert the key back into key cylinder.
-Turn IGN ON
finish the operations within 120 seconds.
Step 2:
Remove the master key from key cylinder within 20 seconds, then press OK
Step 3:
Insert the new you want to program within 10 seconds. then press OK
DON'T TURN THE IGNITION SWITCH ON
Registering key in progress
Key registration is complete.
This key should now start the vehicle.
Press OK to register another key to press Esc to exit the key key registration menu.
Part 2: Program Remote
Now go back to main function menu, select Diagnosis function->Control Unit->Main Body->Special Function->Wireless Code registration
This function is used to add the newly recognized codes for registration while the already registered codes are retained.
Add a wireless remote:
1.The ignition switch is ON. Wait at least 30 seconds after IGN on before clicking OK.
2.Driver side door is opened and the other doors are closed.
3.Driver side door is unlocked.
Step 1:Autel MS906BT diagnostic tool shows current number of remotes registered.
Step 2:Perform following operations within 30 seconds.
On the remote transmitter, push:
1. LOCK and UNLOCK simultaneously for 1 second.
2. Within 2 seconds, press either the LOCK or UNLOCK button again for 1 second
Step 3:
On the remote transmitter, push:
1. LOCK and UNLOCK simultaneously for 1 second.
2. Within 2 seconds, press either the LOCK or UNLOCK button again for 1 second
Wireless Code registration is complete.
Press OK to register another key code, or press Esc to exit the function.
No comments:
Post a Comment