How to use FoxFlash and KT200 ecu programmer MED17 EDC17 free tricore clone service? Most of other tools need patch the files after read out, but Foxflash/new KT200 is free.
How to Clone MED17 EDC17 ECUs with FoxFlash?
The following functions allow you to create a file for cloning Bosch MED/EDC 17 ECUs.
Here is the procedure:
1. Read in BOOT MODE TRICORE or in BENCH TRICORE the car control unit (ECU 1) and the purchased control unit (ECU 2).
Read both Micro [flash] and eeprom data separately.
2.
Select the driver:
->TOOL BOOT
->TOOLS BOOT MODE
-> INFINEON TRICORE Clone Service
Choose ECU you desired to clone
Here is the available list of ECU clone
3.
Load on the first line the Micro file of the car control unit (ECU 1).
Load on the second line the Micro file of the purchased control unit (ECU 2):
4.
Click CLONE & SAVE and the software will save the file for the clone in the selected directory.
5.
Write in BOOT MODE or the file just created on the purchased ECU 2.
Note: The BENCH TRICORE does not work on all ECUs for this type of complete writing. Boot mode is recommended.
REMEMBER:
On the purchased ECU (ECU 2) you must also write the EEPROM of the original car ECU (ECU 1) without making any changes.
https://www.obdii365.com/service/clone-medc17-ecus-with-foxflash.html
No comments:
Post a Comment