How to Change Mazda 6 RCM Module with VCM IDS

Vehicle: Mazda 6 GH 2.0L AT

Purpose: change the RCM (Radiant Configuration Manager ) module config in case of installing a passenger airbag deactivation switch, if it is not there before

Device: VCM-II IDS for Mazda

We connect the VCM 2to the car and laptop, run the VCI Manager , connect to it. We start IDS we are connected to the car in the automatic mode.

Choose Module Programming

The system will ask a question regarding the third character of the VIN-number, then we get into the menu trace)

Choose Programmable Parameters-> RCM

Click the check mark in the lower right corner

The system will once again ask about the VIN-number, agree in this case

We fall into the selection menu configuration RCM

Choosing Fitted

Press the tick in the lower right corner, turn off / on the ignition several times according to IDS prompts , as they say, very simple.

Disclaimer: The tutorial was translated from Russian.

www.obdii365.com