VNCI RNM and Openport 2.0/Godiag J2534 which is a better inexpensive VCI that can be used for diagnosis and programming with Renault CAN CLIP or ADT software?
Renault CLIP:
Both VNCI RNM and Openport work with Renault CLIP software.
Tactrix openport 2.0 original or clone works perfect on CAN-CLiP software but you must make some modifications on Windows registry. (Check: How to set up Openport with Renault CLIP)
VNCI RNM called MTS6535 very good quality Chinese clone, On VCI MTS6535 no other modifications are necessary, works as it is drivers j2534 and CLIP from native DVD.
Openport and other J2534 do not work properly on older K-line models (pre-2005). Openport does diagnosis functions only.
VNCI RNM uses the original driver, so it is fully compatible with both old and new Renault models. RNM device will do coding and programming.
Renault ADT:
Some newer vehicles will have a secure gateway so will need to be unlocked, you may need ADT (Alliance Diagnostic Tool) and the Renault E token to diagnose. ADT is the next generation of vehicle diagnosis and repair tool. For example, Trafic 3 Phase 2 is diagnosed under ADT.
If you diagnose these models with CLIP software, it will report error “the vehicle is not subject to diagnosis with the CLIP device, please switch to the ADT device”.
Renault uses ADT VCI for ADT software. The ADT VCI supports diagnostics, programming, and immobilizer functions for Nissan, Renault, and Mitsubishi vehicles from 1996 onwards.
Openport/Godiag/Scanmatik Pro 2 can not be used as passthru with ADT RENAULT program. These VCIs do not work via DoIP. kts560 and texa do not work via DoIP either.
VNCI RNM is a VCI MTS6535 device. Our customers have tested it working with ADT software without issue.
“VNCİ RNM I advise
ADT It works smoothly.
Token working.”
If you need a Renault/Nissan specific diagnostic tool, go for the VNCI RNM scanner. If you just do basic diagnosis, Openport 2.0 is fine.
No comments:
Post a Comment