What Tool to Clone VAG Delphi DCM6.2V ECU

 Is it possible to clone VAG Delphi DCM6.2V ECU? With which tool? 

Yes, clone is possible.

2 Ways:

1). Flash used (healthy) ECU to correct SW and adapt it online via ODIS. You need immo adaption before you can flash it. Not always possible and odis can fail on adoption used ecu to car.

2). You can use boot mode to read and transfer data for cloning the DCM6.2V

 

Way 2 need full decrypted reads of old and new ecu. You need same HW and SW ecu or as close as possible. Need full reads from each ecu.

Few tools can do this but Flex can make it in boot mode.  If you have Flex You can clone it, just read original and write full dump to new one.

Make full BOOT backup from both ECU’s.  Rewrite via boot full and finish.

TagFlash also able to clone DCM6.2V in boot mode.

 

 

KESS3
Does not support cloning of these ECUs yet.
Kess3 can only read/write these ecus in boot mode… but not to clone them because of OTP.
You won’t be able to write a full decrypted read with kess v3.

 

OBDSTAR DC706/CG FC200/Foxflash/KT200 etc

These programmers only read/write DCM6.2V on bench/in boot mode, they cannot clone this ECU.

DC706 reads DCM6.2V perfectly with P003, P003+ and MP001. All reads verified with each other and Immo data decode looks right. But it cannot clone this ECU.

Autotuner dcm6.2v works well in boot , fast read and write in a few minutes.

Autotuner, Flex and KESS3 will read DCM6.2V via obd VR, other tools boot mode.