Flex Update Ford SID212 via OBD without Unlocking

No unlock. No Bench. Just OBD.
With Magic MotorSport Flex version 7.59.0.0, working on Continental SID212 and SID212EVO ECUs installed on Ford vehicles becomes even faster and more efficient.
The new protocol gives you direct access to the map area and EEPROM memory through the vehicle’s diagnostic port, eliminating the need for Bench unlocking procedures.

This release introduces direct access to the map area and the EEPROM memory without the need to unlock the unit: just connect the red OBD cable to the diagnostic port of the vehicle to start reading.

Moreover, operating times have also been optimized, allowing the file to be obtained even faster and improving workshop efficiency.

Main advantages:

• Direct access via OBD
• No need to unlock in Bench
• Map area and EEPROM read
• Reduced acquisition times
• Faster operations

Update your Flex now and discover a smarter way to work on Ford SID212 and SID212EVO ECUs

Some of the supported vehicles

• Ford Ranger (T6) 2.0L TDCi EcoBlue 213 HP (2021MY)
• Ford Transit (MK9) 2.0L TDCi EcoBlue 106HP (2021MY)
• Ford Mondeo (IV) 2.0L TDCi EcoBlue 179HP (2021MY)
• Ford Kuga (III) 2.0L TDCi EcoBlue 150HP (2021MY)
• Ford Transit Custom (MK9) 2.0L TDCi EcoBlue 131HP (2021MY)

 

This new protocol is available for the following software packages:
OBD Full
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master

FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave

FLS0.5M – SW Flex Full Master

FLS0.5S – SW Flex Full Slave

 

Newly added protocols:

OBD Full

Ford Continental SID212 TC297 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM

Ford Continental SID212EVO TC297 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM

 

Writing time: ~3 minutes and 30 seconds

Reading time: ~2 minutes and 30 seconds