Here is the instruction to reset BMW FEM/BDC mileage with Yanhua ACDP.
NOTE: Only resets mileage in BMW FEM/BDC system.
What’s required:
Yanhua mini acdp host
Module 2 interface board for FEM/BDC immo and mileage
Yanhua BMW FEM/BDC clip adapter
Procedure:
Remove and disassemble FEM/BDC module
Locate and clean eeprom chip 95128/95256
Connect FEM/BDC interface board and FEM clip adapter with FEM module and ACDP host
The new Yanhua FEM clip adapter is recommended, no easy to slip off
Go to BMW Programming BMW FEM/BDC-IMMO Mileage
Perform BMW FEM/BDC initial programming process
2 methods are provided to perform this process
Here we prefer method 1 Automatic ICP programming
Read Key FEM system information
The green indicator on the FEM interface board turns on
Detect VIN, mileage, key frequency and software info
Then it will auto check pin status connection
Once well connected, press OK to continue
Reading coding info.
Auto backup coding data
Downloading data and preprocessing FEM/BDC
This process will take about 20 minutes
Yanhua ACDP write coding data and save
Automatic ICP programming is completed.
Auto save new coding data.
Go back and select Reset Mileage
Make sure you finish BMW FEM/BDC initial programming process
Reset FEM/BDC mileage succeeded
Auto save new mileage data
Restore BMW FEM/BDC module.
https://www.obdii365.com/service/reset-bmw-fem-bdc-mileage-with-yanhua-mini-acdp.html
No comments:
Post a Comment