There are 2 different quality KT200/KTM200 ecu programmer boards. And they are slightly different. One has a crossover board stuck to the back of the board and the other one does not. Looks like there have been revisions between them. The newest one was better quality soldering but looks like 2 chips have been hand soldered on and jumpers set differently.
One with cross overboard in the back is of very poor quality. One without cross-over board is a revision and is of better quality.
Good quality one
without crossover on back. Better soldering also.
Low quality with crossover
The poor quality kt200 won’t even i.d certain modules. Sometimes the toolboot option is useless as it won’t work at all.
Where do you recommend to buy a well made kt200?
Always buy from an authorized dealer. Don’t look cheap.
Obdii365.com have KT200 full and basic version with high-quality boards.
It can do a full backup of edc15 (flash+eeprom) by pinout. No need to open and boot mode which is a rare feature. It has some functions that even my genuine kess3 and Autotuner doesnt.
No comments:
Post a Comment