Autotuner Flex Update Iveco 2019- MD1CS069 ECU by OBD

Both Magic Motorsport Flex and Autotuner and programmer now support the Bosch MD1CS069 ECU OBD protocol for the Iveco Daily.

 

MMS Flex

 

New Flex update, version 7.49.0.0, now available, implementing OBD programming for the most modern Iveco vehicles equipped with Bosch MD1CS069, even those produced after 2021.
Thanks to this new protocol, you can now work directly from the diagnostic port of the vehicle (bypassing the SGW module), or establishing direct connection through the connector.
As of today, working on the map area doesn’t require unlocking the control unit nor shipping it to us: remove DTCs, boost engine performance, or cut consumption, all in a few minutes.

Some of the supported vehicles
Iveco Daily (IV) 2.3L FPT 16v 134HP
Iveco Daily (IV) 3.0L FTP 16v 177HP

 

New protocol available for the following software packages:
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
FLS0.5M – SW Flex Full Master
FLS0.5S – SW Flex Full Slave

Newly added protocols:
OBD
Iveco Bosch MD1CS069 TC299 Read/Write/Checksum Calculation Maps

Writing Time: 2 minutes
Reading Time: 5 minutes

AutoTuner

Big news for your commercial vehicle tuning! You can now work on the latest generation of the Iveco Daily (2019+) equipped with the Bosch MD1CS069 ECU.
This update covers both the highly popular 2.3 Multijet EU6 and the heavy-duty 3.0 EU6 engines.

Maximum Flexibility: OBD or Bench!

This protocol is designed to work equally well via the diagnostic port or directly on your desk (OBD over BENCH). Whether the van is in your shop or you only have the ECU in your hands, you get a 100% real read (Normal Read).

Note: The specific wiring diagram (pinout) for Bench connections is provided directly within the protocol instructions.

Supported Vehicles:

Iveco Daily (2019+) – 2.3 Multijet EU6
Iveco Daily (2019+) – 3.0 EU6

Supported Engines:
2.3 Multijet EU6
3.0 EU6

Method:

OBD Normal Read OR OBD over Bench Get a real reading directly through the OBD port, or work on the bench if you prefer. The pinout is included right in the protocol instructions!

You need the SGW bypass.

Update your Tool today and boost those workhorses!

Key Features

Type: Engine Control Unit (ECU)
Mode: OBD NR
Readout: Calibration
MCU: TC299
Read time: 12min
Write time: 2min
Checksums correction

Compatibility List*

Iveco Model: Daily (2019+)
Iveco Engines: 2.3 Multijet EU6 / 3.0 EU6

*The list may evolve over time.

Ducato with the same ECU will works with Iveco protocol?
Only Iveco. It does not work on Fiat Ducato same ECU.
Even if it’s the same ECU, it’s not the same protection.